EasyManua.ls Logo

Racktivity PM0816-01 - Page 13

Default Icon
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© 2011 Racktivity Inc. 13/25
2100 Seaport Blvd., Suite 400, Redwood City 94063, USA – www.racktivity.com v 2013.11.18
Ambient tab
The Ambient tab shows the environmental parameters being measured.
Sensor
• Airflow: The airflow measured by an optional external sensor (in meters per second)
• Intrusion1: Shows the state of an optional external intrusion detector
• Intrusion2: Shows the state of an optional external intrusion detector
Relative Humidity
• Value: The current relative humidity (in %RH)
• Min: The lowest value since the last reset (in %RH)
• Max: The highest value since the last reset (in %RH)
• Reset: resets the Min and Max columns to the current value
• Warning Min: Sets the minimum value at which an SNMP trap is sent
• Warning Max: Sets the maximum value at which an SNMP trap is sent
• SNMP: if checked SNMP traps will be sent when the Warning Min and/or Warning Max
values are crossed.
Temperature
• Temperature: Shows the state of both the internal temperature sensor (on the first row)
and any connected optional temperature sensors
o Grey background: No sensor connected
o Green background: Connected and active sensor
• Value: The current temperature (in °C)
• Minimum: The lowest value since the last reset (in °C)
• Maximum: The highest value since the last reset (in °C)
• Reset: Resets the Minimum and Maximum columns to the current value
• Warning Level: Sets the maximum temperature that when crossed causes an SNMP trap
to be sent
• SNMP: If checked SNMP traps are sent when the Warning Level is exceeded
After editing the settings on the Ambient tab, press the Save Data button. A pop-up will appear
after the changes have been successfully saved.
Settings tab
General
• PDU Name: Name of the PDU
• Rack Position: Optional administrative parameter that indicates where the PDU is
installed.
Port Name
• Sets the preferred port names, typically the internal identification used for the connected
devices