Need help?Do you have a question about the Radcal Dynalyzer III and is the answer not in the manual?
General| Brand | Radcal |
|---|---|
| Model | Dynalyzer III |
| Category | Medical Equipment |
| Language | English |
Describes the Dynalyzer III's microprocessor-based circuitry, functions, and system capabilities.
Details the physical design, including chassis, displays, and panel connectors of the Dynalyzer III.
Lists potential inaccuracies for mAs readings based on exposure time and displayed mAs values.
Explains derived values like mA, kVp, and trigger levels, and their associated accuracy.
Outlines technical specs for printer, RS-23-2 connector, input power, and environmental conditions.
Details the serial communication port's specifications and its role in data transmission.
Guides users through connecting power, setting up the unit, and performing diagnostic tests.
Explains selection of external, auto, and manual trigger modes for initiating measurements.
Covers using Percent and Preset modes for kVp and mA triggering.
Emphasizes correct trigger level settings for accurate exposure time and current measurements.
Describes the kV delay function to mitigate effects of initial voltage overshoot.
Details low mA measurement procedures, including dual ranging and zero adjustment.
Explains the window delay feature for analyzing specific exposure segments.
Covers tracking exposure counts and recalling historical data.
Instructions for clearing erroneous exposure data within a measurement sequence.
Explains how the reset button clears memory and re-initializes the system.
Details automatic calculation of COV for up to 10 consecutive exposures.
Provides a step-by-step guide for performing standard measurement tasks.
Outlines key calibration checks for X-ray tubes and timers.
Step-by-step guide for installing a new paper roll.
Instructions for replacing the printer ribbon cartridge.
Specifies communication parameters for data output via the RS232 interface.
To Next Page