Raddy PT-3 Manual [EN]
unit is minutes.
Switching off the alarm signal
While the alarm is sounding, press any button except the “SNOOZE/LIGHT” button or press hold the
“SNOOZE/LIGHT” button for 3 seconds to stop the alarm signal.
Snooze Function:
While the alarm is sounding, press the “SNOOZE/LIGHT” button once to activate the snooze function. The
alarm signal sounds again after already been set.
In snooze mode, press any button except the “SNOOZE/LIGHT” button or press hold the “SNOOZE/LIGHT”
button for 3 seconds to exit the snooze mode.
F.Y.I.:
When the snooze function is set to OFF, while the alarm is sounding, press “SNOOZE/LIGHT” does not have
this snooze function.
Maximum/Minimum Temperature/Humidity
To toggle indoor/outdoor maximum, minimum temperature and humidity data, press the “MEM” button:
Once to show the maximum temperature and humidity values.
Twice to sow the minimum temperature and humidity values
Three times to return to the current temperature and humidity levels
To reset the maximum and minimum temperature and humidity, press and hold down the “MEM” button
about 2 seconds. This will reset all minimum and maximum data recorded to the current displayed values.
F.Y.I.:
If the temperature reading is below ranges, the LL.L will be displayed. If the temperature reading is above
ranges, the HH.H will be displayed.
Battery charging and power-on and power-off
When the main unit is in the shutdown state, Press and hold the
“ ”
button on the side for more than 3
seconds to turn on the product. Similarly, in the startup state, press and hold the
“ ”
button for more
than 3 seconds to turn off the machine
The built-in battery of the main unit has a power display. The display of four cells indicates that the battery is
To Next Page
Loading...