Raddy PT-3 - Initial Operation

Raddy PT-3 Manual [EN]
5
C6: Battery compartment
Part D –Wireless Water Temperature Sensor:
A: Channel switch
B: Low battery indicator
C: Temperature signal emission indicator
D: Temperature value
E: LED indicator for signal transmitting
F: Transmitting antenna
G: Unlocking key
H: Channel selection switch
I: °C/°F selection switch
J: Waterproof rubber ring
Initial operation:
 This now, twist the unlocking key of the remote sensor 90 degrees and remove it, twist the main body of
the sensor by removing the upper lid and lower lid with wrench(included) , choose the temperature unit and
channel you need, open the battery cover, insert 2 x AA batteries【note of observing polarity “+” and
“–“ marks】, as shown in below image.
 The temperature unit °C/°F can be selected by turning the switch “I”， the channel can be selected by
turning the switch “H”