Raddy PT-3 Manual [EN]
fully charged, and the display of one cell indicates that the battery is low.
If only the battery frame is displayed and blinks, it means that the battery power is exhausted, and the
product will automatically shut down and enter the standby state. At this time, the external power supply
must be connected for charging. The main unit will only display the battery label when charging when it is
off.
When the main unit is connected to the external power supply, it will automatically charge the built-in lithium
battery, and the battery icon will automatically change the animation display to indicate that it is charging.
When it is fully charged, the battery icon will automatically display the full charge status of four cells.
Background lighting
If the product is powered by batteries, Press the “SNZ/LIGHT” button. Backlight lit 15 seconds.
When the power supply of the product is inserted into the power supply adapter, the battery will
automatically disconnect the power supply, and the backlight will always be bright. Press the “
SET/MODE
”
button to adjust the brightness of the backlight, you can adjust the 4 state: 3 different brightness backlight
and close the backlight. Users can choose according to the personal preferences of different brightness
backlight or turn off the backlight. When the backlight is in the dark brightness or closed state, you can Press
the “SNOOZE/LIGHT” button to lighten the maximum brightness of backlight for 15 seconds.
APP interface description
After the pairing is completed, the APP will automatically jump to the main interface, the product will
automatically update the network time, and report the indoor temperature and humidity, and the
temperature of the three outdoor channels. The APP interface will refresh the data.
The APP can view the historical record of the reported data. Click the record icon at the bottom left to enter
the historical record interface. Click the setting icon at the bottom right to make various settings. The
product will change in real time according to the settings.
To Next Page
Loading...