Need help?Do you have a question about the Radial Engineering Tonebone Bassbone V2 and is the answer not in the manual?
General| Ground Lift | Yes |
|---|---|
| Weight | 1.5 lbs (0.68 kg) |
| Type | Bass Preamp/DI |
| Power Supply | 9V DC |
| Polarity | Negative |
| Boost | Yes |
| Features | effects loop |
| Effects Loop | Yes |
| Outputs | 1 XLR, 1 1/4" |
| EQ | 3-band EQ |
Explains using the Bassbone with a single instrument to act as a two-channel preamp.
Details connecting a second instrument to the INPUT-B jack for two-instrument operation.
Describes using the PZB booster for piezo pickups from upright basses.
Covers using the BLEND function to mix signals from dual-pickup systems.
Controls for switching channels and setting instrument levels.
EQ and high-pass filter controls for tone customization.
Features for managing effects loops, boost, and mute.
Details on instrument inputs and specialized pickup support.
Switches for mixing pickups and assigning boost/mute functions.
1/4" and XLR outputs for amplifier, tuner, and PA system connection.
SEND/RECV jacks for effects, and power supply input with cable clamp.
Switches to manage ground loops and signal phase.
Guide to setting initial control positions and using set & forget switches.
Explanation of how the Bassbone powers on when the supply is connected.
Steps for connecting one bass to channel-1 and the output to the amplifier.
Details on using channel-1 as a straight-through channel with amp EQ.
Explains channel-2 as an override channel with passive-interactive EQ and HPF-2.
How to connect and switch between two different basses.
Using the PZB booster for piezo pickups from upright basses.
Details on the footswitch-activated power booster for solos.
How to convert the boost footswitch to a mute function for silent tuning.
Using the BLEND switch to mix signals from dual pickup systems.
Placing effects before the Bassbone input for dedicated bass effects.
Routing effects through the 1/4" output to the amp, not the PA.
Instructions for connecting pedals to the SEND/RECV jacks and using the LOOP footswitch.
Adjusting the mix of effected signal with the original bass tone.
Connecting the XLR output to a PA or recording console for direct sound.
Lists audio circuit type, frequency response, distortion, dynamic range, and impedances.
Details power requirements, construction materials, finish, dimensions, weight, and warranty.
Outlines the three-year transferable limited warranty terms and conditions.
Provides the required warning regarding chemicals known to cause cancer or reproductive harm.
To Next Page
