Need help?Do you have a question about the Radial Engineering Tonebone and is the answer not in the manual?
General| Input Impedance | 1 M Ohm |
|---|---|
| True Bypass | Yes |
| Type | Overdrive/Distortion |
| Weight | 1.5 lbs |
| Technology | Analog |
| Outputs | 1 x 1/4" |
| Controls | Level, Tone |
| Inputs | 1 x Instrument |
Instructions for unpacking the Tonebone pedal, keeping the box and receipt for servicing.
Guide to powering the Tonebone, allowing warm-up time, and understanding LED indicators.
Guidance on initial control settings, finding unity gain, and experimenting with sound.
Adjusts overall input gain and distortion. Use GAIN switch for more drive.
Boosts gain at preamp input (LOW=0dB, MED=+9dB, HIGH=+20dB).
Balances high frequency ratio between amplifier and ToneBone. Start clockwise.
Provides +7dB & +12dB boost @ 360Hz for cutting through the mix.
Active 'post-distortion' tone control. Boost or cut ±14.5 dB @ 100 Hz.
Adjusts treble response (BRIGHT, FLAT, DARK) for tone shaping.
Active 'post-distortion' tone control. Boost or cut ±10dB @ 4.3KHz.
Adjusts output level without altering tonal characteristics.
Toggles between effect and True-Bypass. On/off LED indicator.
Adjusts overall amount of input gain and distortion.
Provides +7dB & +12dB boost @ 360Hz for cutting through the mix.
Adjusts balance of low & high frequencies in VOICING modes.
Selects passive boost coloration (NOTCH) or midrange filter (FAT).
Active 'post-distortion' tone control. Boost or cut ±14.5 dB @ 100 Hz.
Adjusts treble response (BRIGHT, FLAT, DARK) for tone shaping.
Active 'post-distortion' tone control. Boost or cut ±10dB @ 4.3KHz.
Adjusts output level without altering tonal characteristics.
Toggles between effect and True-Bypass. On/off LED indicator.
To Next Page
