Radiant RS 30 E - Fig. 1

INSTALLATION INSTRUCTIONS
10
B
C
A
3.3 Unpacking
■ The materials (cardboard) used for packing the appliance are fully recyclable.
■ It is recommended that the packing material is only removed prior to installing the boiler. The
manufacturer will not be held responsible for damage caused by incorrect storage of the product.
■ Packing materials (plastic bags, polystyrene, nails, etc.) must not be left within reach of children, in that
these items represent a potential hazard.
A. Place the packed
appliance on the floor (fig.
1) making sure that the
"up” arrow is facing down.
Remove the staples and
open out the four flaps of
the box.
B. Rotate the boiler 90°
while manually supporting
it from underneath
C. Lift the box and remove
the protections. Lift the
boiler by grasping the rear
part and proceed with the
installation.
Fig. 1