9
Frequency Range ........................................
..............................................................................
..........................................................
Tuning Step ...................
Power Supply ................................... 4 x C batteries or 120V AC
Output Power .............................................................. 1W x 1 RMS
Actual product may vary from the images found in this document.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
•
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires that you
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
To Next Page
Loading...
