14
Using the Meter
to display 4001 or more units) or underflow (the
meter tries to display 379 or fewer units).
3. To select manual range mode, press
RANGE. disappears. Then repeatedly
press
RANGE until the range you want appears.
The decimal point shifts each time you press
RANGE.
4. Hold down
RANGE for about 2 seconds. The
meter exits manual range mode and returns to
its auto range mode.
5. To select the temperature range you want to
display (
°
C or
°
F), rotate the function
selector to
°
°°
°
C/
°
°°
°
F /
V, press SELECT once,
then repeatedly press RANGE until 9
99
9 or <
<<
<
appears.
6. Set the meter to the different measurement
ranges. The unit of measure that appears on
the display shows the currently set range. For
example,
cL
cLcL
cL appears in the 400 mV range.
Note the position of the decimal. If
&$&&&ýL
&$&&&ýL&$&&&ýL
&$&&&ýL
appears, the meter is set to measure less than
4 volts. If &&&&L
&&&&L&&&&L
&&&&L appears, the meter is set to
measure up to 1000 volts.
Read the range in volts, ohms, capacitance, or
amps as indicated by the position of the deci-
mal point.
4CPIG &KURNC[
400 mV
ZZZ$ZýcL
ZZZ$ZýcLZZZ$ZýcL
ZZZ$ZýcL
4 V
Z$ZZZýL
Z$ZZZýLZ$ZZZýL
Z$ZZZýL
40 V
ZZ$ZZýL
ZZ$ZZýLZZ$ZZýL
ZZ$ZZýL
400 V
ZZZ$ZýL
ZZZ$ZýLZZZ$ZýL
ZZZ$ZýL
1000 V DC/750 V AC
ZZZZýL
ZZZZýLZZZZýL
ZZZZýL
400
µ
A
ZZZ$Zý
ZZZ$ZýZZZ$Zý
ZZZ$Zý
µ
µµ
µ
7
77
7
4 mA
Z$ZZZýc7
Z$ZZZýc7Z$ZZZýc7
Z$ZZZýc7
40 mA
ZZ$ZZýc7
ZZ$ZZýc7ZZ$ZZýc7
ZZ$ZZýc7
AUTO
22-812.fm Page 14 Monday, April 8, 2002 1:32 PM
To Next Page
Loading...
