12
Beyond the Basics
sound check
1. Select an input source to play.
2. Adjust its volume (CH control) to its preset signal level (see
“presetting input signal levels” on Page 9). The mixer’s
LED meters should read 0dB or less.
3. Adjust your receiver/amplifier’s volume to an appropriate
level for the location or event where the mixer will be
used.
4. Adjust the LEFT CHANNEL and RIGHT CHANNEL frequency controls
to your preference (see “using the seven band equalizer”
on page 15). If this causes the LED meters to exceed 0dB,
adjust MASTER downward until their readings return to 0dB.
Adjust your output device’s volume accordingly.
To Next Page
Loading...
