17
Beyond the Basics
frequently asked questions
Q - I set up my mixer according to the instructions. Why isn’t
it working?
A - Make sure you are connected to a “live” AC outlet.
- Verify that all sources are securely connected.
- Check the fuse and replace it if needed.
Q - Why is there no signal from my input source?
A - Make sure OFF/ON/TALKOVER is not set to TALKOVER.
- Make sure the input source is turned on.
- Check the mixer and source control settings.
- Check connections between the mixer and input source.
Q - Why do I hear a humming noise from the PHONO source?
A - Make sure the PHONO 1 or PHONO 2 source’s ground
wire is connected to the mixer’s GND terminal.
Q - Why do I hear a humming noise from another input
source?
A - Make sure there are no low-level inputs connected to the
mixer’s LINE input jacks.
Q - Why am I getting microphone feedback (squealing)?
A - Move the microphone further away from the output
speakers or use a directional microphone.
To Next Page
Loading...
