Radio Shack 33-2055 - Installing the Battery

CONTENTS
INSTALLING
THE BATTERY
Installing the Battery ........................................ 5
Making Measurements ..................................... 7
..............................
Setting the Sound Range 7
....................................
Setting the Weighting 8
Setting the Response
.................................. 9
...................
Making Normal Measurements 10
................
Making Maximum Measurements 11
.........................................
Level Indications 12
...........................
U nderrange Indication 13
Overrange Indication
............................. 13
..........................................
Using Data Hold 14
Making an Integrated
..........................
Average Measurement 15
Making Maximum and Minimum
Measurement During an
Undetermined
Time Period ................... 17
............
Checking Stereo System Acoustics 18
...................................
Calibrating the Meter 19
Care and Maintenance
............................. 20
Specifications ................................................. 21
The meter requires one 9-volt battery for opera-
tion. Follow these steps to install the battery.
1. Set RANGE to OFF.
n
2. Remove the battery compartment cover bv
pressing in both sides and lifting off the cover.
-
\
,
Press
3. Install the battery as indiczed by the diagram
marked in the compartment. Place the battery
over the red ribbon to make it easy to remove
the battery later.