Radio Shack 43-3901 - Mounting the Phone on a Wallplate; Mounting the Phone Directly on a Wall

5
Mounting the phone on a wallplate:
1. Pressandliftoutthehandsettab.Rotateit
180°,andsnapitbackintoplacesoitwill
holdthehandsetinplacewhenthephoneis
mountedonthewall.
2. Insertthemountingbracket’stwotabsintothematching
slotsonthebottomofthephonebase.Pressdownand
slidethebracketupwarduntilthetabssnapintoplace.
3. Plugoneendofthesuppliedshortphonecordintothe
LINEjackonthebackofthephonebase.
4. Plugthecord’sotherendintothewallplatejack.
5. Alignthebase’skeyholeslotswiththewallplatestudsand
slidethephonedownwardtosecureit.
Mounting the phone directly on a wall:
Tomountthephonedirectlyonawall,inadditiontothe
wallplatesteps,youneedtwoscrews(notsupplied)withheads
thattintothekeyholeslotonthebottomofthebase.
1. Drilltwoholes3
1
/
4
inches(83mm)apart(vertically).Then
threadascrewintoeachhole,lettingtheheadsextend
about
1
/
4
inch(6mm)fromthewall.
2. Placethekeyholeslotsoverthescrews,thenslidethebase
downuntilitissecure.
Tab
Mounting
bracket