Radio Shack Cassette Tape Recorder User Manual

14
Recording
USING THE CUE MARKER
To mark the beginning of a section of a recording, press
CUE
MARKER
for about 3 seconds during the recording. This records
a brief tone on the tape. When you press
FAST-F/CUE
or
RE-
WIND/REV
while the tape plays, you hear the tone when the
tape reaches the point you marked.
USING AN EXTERNAL MICROPHONE
The recorder’s built-in microphone works well in most situa-
tions, but you can connect an external microphone (not sup-
plied, available at your local RadioShack store) with a
1
/8-inch
(3.5-mm) plug to the recorder’s
MIC
jack. This automatically dis-
connects the built-in microphone.
Set
VOX/TONE
to
ON
for VOX recording, or to
OFF
for manual
recording.
If the microphone has an ON/OFF switch for remote control,
connect the microphone to the
REM
and
MIC
jacks. Then you
can start and stop recording with the switch on the microphone.
RECORDING FROM EXTERNAL SOURCES
You can record directly from a tuner, a radio, or a TV that has a
1
/8-inch (3.5-mm) jack. Use a dubbing patch cord (not supplied,
available at your local RadioShack store) to connect the record-
er’s
MIC
jack to the headphone output jack of an external com-
ponent. Set
VOX/TONE
to
OFF
, then proceed with manual
recording.

Radio Shack Cassette Tape Recorder Specifications

General

Brand	Radio Shack
Model	Cassette Tape Recorder
Category	Cassette Player
Language	English