OPERATION
TURNING ON THE
DETECTOR
1.
Hold the detector
in
a comfortable
position.
2. Turn on the detector by turning
SENSITIVITY clockwise until it
clicks.
i'
,-::
- ~
OFF
•, ~
POWER
·-
,. . ,
HIGH
I
SENSITHlffY
The detector beeps 3 times,
arrows point to all options on both
displays, and the LOW
BAT
indica-
tor lights for a few seconds. Then
an arrow points to ALL METAL on
the bottom display. ·
Note:
Many detector problems are
caused by weak, dead, or improperly
connected batteries.
If
the detector
does not turn on, has weak volume,
will not tune properly, operates errati-
c~lly, or drifts, check both batteries.
SETTING A TARGET
MODE
Your detector has three built-in target
modes which determine what types of
metal your detector will search for and
reject.
• ALL METAL
• DISC (discrimination)
• AUTO (automatic) NOTCH
When the detector is set to a target
mode, the top display is blank until the
detector detects a specific type of met-
al.
Then the arrow points to that metal
size and type.
ALL
METAL
When the detector is set to ALL MET-
AL,
it beeps and displays an indicator
when it detects
any
type of metal as
long as the metal is under the search-
coil and the searchcoil is moving. You
must sweep the searchcoil over the
metal for the detector to detect it.
The detector automatically sets itself
to this target mode when you first turn
it on. Adjusting DISC/NOTCH (see "Ad-
justing DISC/NOTCH" on Page 14) has
no effect
in
this mode.
9
To Next Page
Loading...
