BG TECH.
VERSION III
2001/2/28
7. A : This icon shows when RX mode is in Air band.
8. battery icon : Battery icon indicates the battery strength.
9. B (key symbol) : this indicates that the key pad control is disabled to prevent accidental setting changes.
10. XBO : This is “Cross Band Operation”. When you use different frequencies for TX and RX, this will
indicate you are using cross band operation.
11. MR (memory Channel Recall) : let you select a memory location using CH.
12. S: This appears when there is a receiving signal as a receiving indicator. When it is flashes, power save
mode is enabled.
13. LM: “L” indicates the low TX power position . “M” indicates the mid TX power position.
14. SIGNAL INDICATOR BAR: It shows the relative signal strength.
15. Main Frequency display in the middle: This is to show RX frequency
16. Sub Frequency display in the bottom: This is to show TX frequencies and alphanumeric characters and
Compass. In compass mode, the first 2 digit will show the direction in Alph. such as NW, SE, or
something. And the last 3 digits will show the degree of direction such as 360, 180, 90, 45.
17. 2 digits below “MR” : This is memory address.
To Next Page
Loading...
