BG TECH.
VERSION III
2001/2/28
MEMORY OPERATION
Your transceiver has 100 standard memory locations that you can use to store frequencies for quick access.
You can store frequencies used for the VHF, weather, and UHF bands. When you store a frequency, all other
settings associated with that frequency (such as the repeater offset and CTCSS tones) are stored as well.
STORING A TRAMSMIT/RECEIVE FREQUENCY (MEMORY WRITING)
Select the freq. you want to store. Once you selected a frequency, the other values such as the
repeater offset and the CTCSS tones for that frequency are also stored in the memory location.
Press “F” + “MW(MR)”. The last used memory location appears and MR flashes on the display.
Repeatedly press arrow key or turn CH rotary switch to select the desired memory
location. Press “F + MW” again to store the selected frequency and exit the memory mode. You
can use up to 100 memory locations to store the frequency.
RECLLAING MEOMIRES (MEMORY READER)
To recall saved memory settings, press “MR”. MR appears and the last used memory location
number appears beneath MR. Then rotate or press CH switch or up/down keys to select a different
memory location. When pressing “SC”, it scan memory channels To return the VFO mode,
press .
.If there is a channel skipped, “MR” blinking. On scan mode, this channel is skipped. If “SC” is
pressed again, it returns to VFO. In scan mode, if there is a signal, it will stop for 8 sec. and scan
again.
CHECKING MEMORY LOCATION SETTINGS
Press “MR”, then rotate CH switch (or press up/down arrow keys) to select the memory location.
Then hold down “M” key. The settings stored in the memory in the memory location appear in
sequence starting with the squelch setting value and ending with the frequency.
CLEARING A SINGLE MEMORY
Press “F” + “CLR(6)” to clear the selected memory location. The next location in sequence appears.
To Next Page
Loading...
