12
Preparation
1. Mark the position of the screw hole.
2. In the marked location, drill a hole
slightly smaller than the nail or
screw.
Caution:
Be careful not to drill into
any objects behind the wall.
3. Slide the wire bracket off the outdoor
sensor.
4. Push the nail or screw tip through
the small loop on the wire bracket,
then drive the nail or screw into the
wall.
5. Slide the outdoor sensor onto the
wire bracket.
63-1032.fm Page 12 Thursday, June 22, 2000 11:29 AM
To Next Page
Loading...
