6
Programming the Weatheradio‚
ATTACHING THE BELT CLIP
Insert the clip into the hole at the back
of the weatheradio until it clicks. To
remove the belt clip, press the button
on the tip of the clip and pull it out.
ATTACHING THE WRIST
S
TRAP (NOT SUPPLIED)
Slide the wrist strap’s small loop under
the bar at the back of the weatheradio.
Then pull the strap’s large loop through
the small loop and fasten it.
PROGRAMMING THE
WEATHERADIO
Your Weatheradio
is pre-programmed
with seven NOAA broadcast
frequencies (channels 1-7). Depending
on your location, you might need to
select a different channel.
Your Weatheradio
is preset to receive
any weather alert broadcast within
about a 50 mile radius. The first time
you use your Weatheradio
, it scans
for the strongest channel and receives
all SAME alert signals broadcast within
a 50 mile radius of its location. Ô
Ô NOTE Ô
• The weatheradio
does not receive alert
To Next Page
Loading...
Need help?
General
