21
6. When the scanner finds an
active frequency, you can do
one of the following:
• To store the displayed fre-
quency into the current moni-
tor memory, quickly press
MON
.
• To continue the search, press
D or —.
• To hold the frequency, press
LIMIT
.
-H-
appears.
Press
LIMIT
again to cancel the
hold and resume the limit
search.
Notes:
• If you press D or — during the
hold mode, the frequency
changes in the current step
increment toward the upper or
lower limit (see “Specifica-
tions” on Page 42).
• If you tune to a search skip
frequency, the display shows
LOCKOUT
(see “Search Skip
Memory” on Page 22).
Direct Search
A direct search lets you specify a
starting frequency, then search for
active transmissions above or below
the specified frequency.
Note:
You can also use the scan-
ner’s delay feature while using direct
search (see “Using the 2-Second De-
lay” on Page 27).
Follow these steps to search for ac-
tive frequencies using a direct
search.
1. Press
MANUAL
.
2. Using the number keys, enter
the frequency (including the dec-
imal point) you want to start the
search from, or the channel
number containing the starting
frequency.
3. Press D to search up or — to
search down starting from the
specified frequency or channel.
-d-
,
SEARCH
, and s or t
appear, and the next available
monitor memory flashes.
Note:
If you enter an invalid fre-
quency,
Error
appears. Re-
peat Steps 2 and 3.
20-417.fm Page 21 Wednesday, August 4, 1999 11:33 AM
To Next Page
Loading...
