41
Beyond the Basics
programmed, F1 appears.
Press
e or d to change the displayed FIPS code from F1 to
F15. If a FIPS code is not programmed, ------- appears.
Use the keypad to enter the FIPS code. Press ./CLR to cancel
an inputted FIPS code. Press E to store the FIPS code. Press
0 then E to clear a FIPS code. ------ appears. If an invalid value
has been inputted, the FIPS code is cleared.
To set the scanner so it alerts you when you receive any FIPS
code, press
e or d to move ALLFIPS. Then press E. Then go
to WX hold mode.
To set to alert only the area you have programmed, press
e
or d to move F1 to F15. Then press E. Then go to WX hold
with WX alert.
Press FUNC + WX ALT to exit NWR SAME alert mode.
To Next Page
Loading...
