28
To skip a frequency, press S/S when the
scanner stops on the frequency during a
search. The scanner stores the frequen-
cy in memory and automatically resumes
the search.
To clear a single frequency from search
skip memory so the scanner can stop on
it during a search, follow these steps.
1. Press
HOLD to hold the search.
2. Press
) or ( to select the frequency. L/O appears.
3. Press
S/S. L/O disappears from the display.
To clear all the search skip frequencies at once, during a search, press
HOLD,thenholddownS/S until the scanner beeps twice (about 3 sec-
onds).
Notes:
• If you skip all the frequencies in the weather band, the scanner will
not start searching. In this case, the scanner sounds three beeps.
• If you program more than 20 frequencies to skip, each new fre-
quency replaces one you already stored, starting from the first fre-
quency you stored.
• You can manually select a skipped frequency.
L/O appears on the
display when you select a skipped frequency.
MANUALLY SELECTING A CHANNEL
You can continuously monitor a single channel without scanning. This
is useful if you hear an emergency broadcast on a channel and do not
want to miss any details — even though there might be periods of si-
lence — or if you want to monitor a specific channel.
RACE
MAN
PROG
BAND
SCAN
HOLD
DATA
12
3
1-10
11-20
21-30
H/S
S/S
4
56
31-40
41-50 51-60
PRIORITY
L-OUT
DEL
7
8
9
61-70 71-80 81-90
0
E
91-100
KEYLOCK
CLEAR
WX
20-513aPAGE29.fm Page 1 Monday, May 5, 2003 1:51 PM
To Next Page
Loading...
