29
Note: You cannot use this procedure to select a car number. See
“Viewing Frequencies Associated with a Car Number” on Page 33 to
select a car number.
To manually select a channel, press
MAN
, enter the channel number,
then press
MAN
again. Or, if your scanner is scanning and stops at the
desired channel, press
MAN
once.
Pressing
MAN
additional times causes your scanner to step through the
channels. To resume scanning, press
SCAN
.
SCANNING CHANNELS
To begin scanning channels, press
SCAN
. The scanner scans through
all non-locked channels in all banks that are turned on, from the lowest
to the highest channel number. (See “Turning Memory Banks On and
Off” and “Locking Out Channels” on Page 35).
When the scanner finds a transmission, it stops on it. Two seconds af-
ter the transmission ends, the scanner resumes scanning.
Note: If
SQUELCH
is adjusted so you always hear a hissing sound, the
scanner does not scan properly.
DELETING A FREQUENCY FROM A
CHANNEL
1. Press
PROG
.
2. Enter the channel number that contains the frequency you want to
delete, then press
PROG
.
3. Press
DEL
. The frequency is deleted.
20-513.fm Page 29 Wednesday, August 4, 1999 2:39 PM
To Next Page
Loading...
