21
6.2.1 Scanning modes
The scanner is configurable to one of three ways of operation: Time, carrier or search, each of which is explained in further
detail in their respective section below.
Setting scanner mode
1. Press the
key to enter the menu.
2. Enter [2] [1] on your numeric keypad to come to scanner mode.
3. Press the
key to select.
4. Use the / keys to select scanning mode.
5. Press the
key to confirm and save.
6. Press the
key to exit the menu.
• Time operation
In Time Operation (TO) mode, the scanner stops when it detects a signal, and after a factory preset time out, it resumes
scanning.
• Carrier operation
In Carrier Operation (CO) mode, the scanner stops when it detects a signal, and after a factory preset time with no signal it
resumes scanning.
• Search operation
In Search Operation (SE) mode, the scanner stops when it detects a signal.
To resume scanning you must press and hold the
key again.
6.2.2 Frequency scanning
This function can scan the frequency.
a. In frequency mode, press
key for more than 2 seconds. The radio will start scanning the frequency according to the
set frequency step.
b. You can change the scanning direction with the / keys.
c. Press
key to stop the scanning.
Note: for Scan mode, see Menu No.21.
To Next Page
Loading...
