Why can't others hear my transmission on Radioddity FS-T1 Two-Way Radio?
If others can't hear your transmission on your Radioddity Two-Way Radio, it might be because your CTCSS or DCS settings don’t match theirs; in this case, change your CTCSS or DCS setting to match your peers. Alternatively, you may be too far apart. Try moving closer to improve communication.
What to do if the LED indicates reception, but the speaker is silent on Radioddity FS-T1 Two-Way Radio?
If your Radioddity Two-Way Radio's LED indicates reception but the speaker is silent, the volume may be too low. Try turning up the volume. Also, check if CTCSS or DCS is enabled. If so, change your CTCSS or DCS settings to match those you're trying to communicate with, or turn CTCSS or DCS off.
Why does Radioddity FS-T1 Two-Way Radio transmit without touching the PTT?
If your Radioddity Two-Way Radio transmits without touching the PTT button, the VOX feature may be enabled. Try turning VOX off. If the issue persists, the VOX sensitivity might be too high; in that case, turn down the VOX sensitivity.
How to fix Radioddity FS-T1 that doesn’t start?
If your Radioddity Two-Way Radio doesn’t start, it could be due to a low battery. Try changing or recharging the battery. Another possibility is that the battery isn't correctly installed. Remove the battery and reinstall it to ensure proper contact.
Why does the battery die quickly on Radioddity Two-Way Radio?
If the battery on your Radioddity Two-Way Radio dies quickly, the battery may be dead. In this case, purchase a new battery. Alternatively, the battery might not be fully charged; try recharging it completely.
Please read the following brief instructions, non-compliance with these rules may cause danger or violate the law.
50 CTCSS tones and 104 DCS codes. Transmission time-out timer, VOX, backlight, battery saving, dual channel standby.
Steps to unbox, install battery, power on, and start talking with the radio.
Explains CTCSS/DCS for selective calling to ignore unwanted calls.
Procedure to set the TX code, selecting from OFF/67.0-754N. Saves settings and exits.
Procedure to set the squelch level from 0-9 to mute speaker when no signals are present.
Eliminates manual transmission switching. Adjust VOX gain for optimal voice recognition.
Lists common symptoms, possible causes, and solutions for radio issues.
General| Channel Capacity | 16 |
|---|---|
| Antenna Impedance | 50Ω |
| Modulation | FM |
| Operating Temperature | -20°C to +60°C |
| Waterproof Rating | IP54 |
| Power Output | 5W |
| Operating Voltage | 7.4V |
| Channel Spacing | 25kHz |
To Next Page
