Radioddity FS-T1 - Chapter 4. Computer Programming; Troubleshooting

Chapter 4 - Computer Programming
2. Weather forecast channel setting mode
In the weather forecast receiving mode, press the △ and ▽ keys to select weather forecast
channel: CH1-CH10
CH1:162.550MHz CH2:162.400MHz CH2:162.475MHz CH4:162.425MHz CH5:162.450MHz
CH6:162.550MHz CH7:162.525MHz CH8:161.650MHz CH9:161.775MHz CH10:163.275MHz
VOICE PROMPTS
This function sets the voice prompt switch
Procedure 3.14 setting VOICE PROMPTS
1. Press the [MENU] key to enter the menu.
2. Use the △ and ▽ keys to enter menu-15:VOICE PROMPTS
3. Press the [MENU] key to select.
4. Use the △ and ▽ keys to select: OFF/CHI/ENG.
5. Press the [MENU] key to confirm and save.
6. Press the [MONI] key to exit.
If you have computer programming needs, download programming software at
https://www.radioddity.com/support/.
Appendix A. Troubleshooting
possiblesymptom
The radio
doesn’t start
The battery
dies quickly
The LED indicates
reception, but the
speaker is silent.
Others can’t hear
my transmission.
The radio transmits
without touching the
PTT.
The battery is too low.
The battery isn't correctly installed.
The battery is dead.
The battery isn't fully charged.
Volume is too low.
CTCSS or DCS enabled
Their CTCSS or DCS settings
don’t match yours.
You're too far apart.
The VOX is enabled.
VOX sensitivity is too high.
Change or recharge the battery.
Remove the battery and reinstall it.
Purchase a new battery.
Recharge the battery.
Turn up the volume.
Change your CTCSS or DCS to
match those you're trying to
communicate with.
Turn CTCSS or DCS off.
Change your CTCSS or DCS
Setting to match your peers.
Move in closer.
Turn VOX off.
Turn down VOX sensitivity.
solution