22
6.2.3 Channel scanning
This function can scan the channels.
a. In channels mode, press
key for more than 2 seconds. The radio will start scanning according to the channel you set.
b. You can change the scanning direction with the / keys.
c. Press
key to stop scanning.
Note: for Scan mode, see Menu No.21.
6.2.4 Scan CTCSS
The function allows scanning the frequencies with CTCSS tone enabled.
a. In standby mode, press
[1][4], “Scan CTCSS” will appear on the display.
b. Press
key and the scan of CTCSS tones will start.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.2.5 Scan DCS
This function allows scanning the frequencies with DCS code enabled.
a. In standby mode, press
[1][5]; the display will show “Scan DCS”.
b. Press
key and the scan of DCS codes will start.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.3 Manual Programming (Channels Memory)
Memory channels are an easy way to store commonly used frequencies so that they can easily be retrieved at a later date.
The radios feature 999 memory channels that each can hold: Receive and transmit frequencies, transmit power, group
signaling information, bandwidth, ANI/ PTT-ID settings, and a six-character alphanumeric identifier or channel name
1
.
Frequency Mode vs. Channel Mode
In standby mode, press the [VFO/MR] key to switch between frequency (VFO) mode and channel (MR) mode.
To Next Page
Loading...
