Radioddity GC-5 Series - Troubleshooting Guide; Common Radio Operation Issues; Communication and Noise Resolution

27
The numerical keys, as well as the , and , keys correspond to the matching DTMF codes as you would expect. The A,
B, C and D codes are located in the
,, and keys respectively.
To send DTMF codes, press the key(s) corresponding to the message you want to send while holding down the PTT key.
If you have the keypad lock enabled on your radio, you can still send DTMF tones the regular way without having to unlock
your radio.
6.9 Customization
The radio allows you to define visual and audible features such as Display Illumination Time, MR/Channel Mode Display
Format, Power On Message, Power On password, Keypad Beep, Roger Beep, Voice Prompt, etc. to suit your usage habits.
6.9.1 Display backlight (ABR) - MENU 7
In standby mode, press + 7. The screen will display “ABR ”.
Press
key to enter the function. Press the / keys to select the always-on/required delay time
(ON/5sec/5sec/10sec/15sec/20sec) the backlight of the display, then press
key to confirm.
To return to the standby mode press
key.
6.9.2 Beep PROMPT (BEEP) - MENU 8
If you enable this function, every time a key is pressed, you will hear a Beep tone.
In standby mode, press
+ 8. The screen will display “BEEP PROMPT”.
Press
key to enter the function. Press the / keys to turn ON/OFF the beep function.
Press
key to confirm and exit to return to standby mode.
6.9.3 Voice function (VOICE) - MENU 17
In standby mode, press + 17; the screen will display “VOICE”.
Press
key to enter the function. Press the / keys to select OFF/ON. Confirm your selection by pressing MENU.
To return to the standby mode press
key.
6.9.4 Language of the MENU (LANGUAGE) - MENU 18
This section shows the language of the MENU (English).