Radioddity GC-5 Series - Technical Specifications; General Radio Specifications

34
24
MDF-A
- Channel Mode A
Display
•CH [0]: Displays the channel number
•NAME [1]: Displays the channel name.
•FREQ [2]: Displays programmed Frequency
[A] MR/Channel Mode Display Format
Note: Names must be entered using software.
25
MDF-B
- Channel Mode B
Display
•CH [0]: Displays the channel number
•NAME [1]: Displays the channel name.
•FREQ [2]: Displays programmed Frequency
[B] MR/Channel Mode Display Format
Note: Names must be entered using software.
26
BCL
- Busy Channel
Lock-out
OFF [0] | ON [1]
Disables the [PTT] key on a channel that is
already in use. The transceiver will sound a beep
tone and will not transmit if the [PTT] key is
pressed when a channel is already in use.
27
AUTOLK – Automatic
Keypad Lock
OFF [0] | 5 [1] | 10 [2] | 15 [3]
Set the automatic keyboard lock delay time. To
prevent the keyboard from being accidentally
triggered.
When turned on, if the keyboard is not used
within a predetermined delay time, the keyboard
will be locked. Pressing the key for 2
seconds will unlock the keypad.
28
SFT-D
- Frequency Shift
Direction
•OFF [0]: TX = RX (simplex)
•+ [1]: TX will be shifted higher in frequency
than RX
•- [2]: TX will be shifted lower in frequency
than RX
Enables access of repeaters in VFO/Frequency
Mode
29
OFFSET - Frequency
shift amount
00.000 - 69.990 in 10 kHz steps
Specifies the difference between the TX and RX
frequencies
30
MEMCH - Store a
Memory Channel
001 - 999
This menu is used to either create new or modify
existing channels (001 through 999) so that they
can be accessed from MR/Channel Mode.
31
DELCH - Delete a
memory channel
001 - 999
This menu is used to delete the programmed
information from the specified channel (001
through 999) so that it can either be
programmed again or be left empty.