Radioddity GC-5 Series - Page 38

35
32
AL-MOD
- Alarm Mode
•SITE [0]: Sounds alarm through your radio
speaker only
•TONE[1]: Transmits a cycling tone
over-the-air
•CODE [2]: Transmits '119' (911 in reverse)
followed by the ANI code over-the-air
•SITE: Sounds alarm through your radio speaker
only
•TONE: Transmits a cycling tone over-the air
•CODE: Transmits '119' (911 in reverse?)
followed by the ANI code over-the-air
33
STE
- Squelch Tail
Elimination
OFF [0] | ON [1]
This function is used eliminate squelch tail noise
between BaoFeng handhelds that are
communicating directly (no repeater).
Reception of a 55 Hz or 134.4 Hz tone burst
mutes the audio long enough to prevent hearing
any squelch tail noise.
34
RP-STE - Squelch Tail
Elimination
OFF [0] | 1 - 10
This function is used eliminate squelch tail noise
when communicating through a repeater.
35
RPT-RL
- Delay the squelch tail
of repeater
OFF [0] | 1 - 10
Delay the Tail Tone of Repeater (X100
milliseconds)
36 ROGER - Roger Beep OFF [0] | ON [1]
Sends an end-of-transmission tone to indicate to
other stations that the transmission has ended.
37 TONE-Tone -burst 1000[0]|1450[1]|1750[2]|2100[3]
To send out a tone-burst; you simultaneously will
press a key while holding down the PTT. No
further configuration required using this feature.
38 MENU EXIT TIME
5 [0] 10[1] - 60[10] in 5 second steps
(TIMEOUT-5)/5=[n]
The time setting for menu exit without menu
operation.
39 VOX DELAY
0.5 [0] 0.6[1] -2.0[15] in 0.1 second steps
(TIMEOUT-0.1)/0.1=[n]
There’s a brief delay between when you finish
talking and the radio returns to tx mode; this
delay can be adjusted.
40
POWER ON MSG
- Power On Message
LOGO[0]|VOLTAGE[1]
Welcome message displayed immediately after
startup.
The LOGO is programmed by the manager.
41
VOICEPRI - Frequency
hopping system
OFF [0] | ON [1]
Activate the frequency hopping function to
prevent interference from outside the group
42
RESET
- Restore defaults
VFO [0] | ALL [1]
Resets the radio to factory defaults, with some
exceptions.