10
2) Use the or buttons to select the desired setting:
oF: Disabled
1. Local alarm, the radio itself emits an alarm sound;
2. Send an alarm tone on the current channel to signal to group members that you need help.
3) Press the PTT button to exit menu or
/MENU button to continue set up.
WARNING: The Distress Alert feature should only be used in a true emergency. If the receiving group does not
respond to the distress signal, Radioddity will not assume any responsibility.
Keypad beep
To deactivate the keypad beep, follow these steps:
1) Press the
/MENU button 7 times and until “ ” is displayed.
2) Use the
or buttons until the display shows “ ”.
3) Press the PTT button to exit menu or
/MENU button to continue set up.
Now you won’t hear any beep at the pressure of any button.
ROGER BEEP (End transmission tone)
When your transmission is finished (PTT released), Radioddity PR-T6 gives out a sound that indicates to the other
party that s/he can start talking. This function is enabled by default.
To deactivate it:
1) Press the
/MENU button 8 times and until the display shows “ ”;
2) Using the buttons
or select “off” and “ ” will be displayed;
3) Press the PTT button to exit menu or
/MENU button to continue set up.
Dual Watch Mode
Your radio has a DUAL WATCH function, to enable user to scan 2 channels for any activity. The first channel will be
the current channel setting and the second channel will be the selected channel on the.
To set another channel and start Dual Watch:
1) Press the
/MENU button 9 times and until the display shows “ ”;
2) Using the buttons
or select the channel, then press /MENU.
3) Using the buttons
or select the CTCSS/DCS, then press /MENU.
4) The radio starts to Dual Watch.
The screen will alternate between home channel and Dual Channel Monitor channel.
To Next Page
Loading...
Need help?
General
