7
Scanning Sub-Codes
Press and hold /SCAN button to enter the Sub-Codes scanning.
A flashing "CTC/DCS" will be in the left status display to indicate the radio is in Sub-Codes scanning mode.
In this mode, the lower display will cycle through the Sub-Codes as they are being tested. Once the bits of the
received Privacy code are determined, the "CTC/DCS" indicator will stop flashing.
Press the [PTT] button to save the scanned tone into memory.
During scanning, press and hold
/SCAN button to exit Sub-Code scanning.
Using the Flashlight
You can use this radio in an emergency. If you press button, the radio turns on the high-intensity LED flashlight
on your radio.
• Your radio operates normally when the emergency strobe is activated.
1) Press
button once, it will turn on continuously. (Always On mode)
2) And then, press
button once, the Strobe Light emits the emergency signal. (Strobe emergency mode)
3) And then, press
button once, the light will be turned off.
Emergency Alert
The Emergency Alert feature can be used to signal members in your group for help. The emergency alarm
function is activated by menu operation.
To activate the emergency alert function, press and hold the
button for 3 seconds. The radio will send out a
loud siren sound and the flashlight will flash.
Press the
button to exit the emergency alert function.
WARNING: The Emergency Alert feature should only be used in the even of an actual emergency.
To Next Page
Loading...
Need help?
General
