RD400PDL-2/PXL-2 User Guide
Transmitter Use
Live Plug Connector
Applies the Transmitter signal to a live domestic
power socket and via the domestic wiring system
onto the service cable and the supply cable in the
street. The signal should be detectable on the
supply system to a few hundred paces each side
of the point of application.
Note: Do not connect the Transmitter to live cables
without using a Plug Connector or Live Cable
Connector.
Procedure
Connect the Live Plug Connector to the
Transmitter and to the live domestic power socket.
Switch on the socket.
Note: Live Plug Connector contains a protection
unit to protect the user and the Transmitter from
mains voltage up to 250V.
To Next Page
Loading...
