Radiolink Electronic Limited
www.radiolink.com
1. The antenna must be kept as straight as possible. Otherwise it will reduce the effective range.
2. Large model aircraft may of some metal part interfering signal, in this case the antenna should
be placed at side of the model.
3. The antenna must be kept away from conductive materials, such as metal and carbon by at
least a half inch. The coaxial part of the antenna does not need to follow these guidelines, but do
not bend it in a small radius.
4. Keep the antenna away from the motor, ESC, and other noise sources as much as possible.
5. The receiver can be packed by sponge or foam for shocking proof when it is installed to the
model.
After all of the above steps finished, now the program functions to assure it under control of
transmitter with a right connection.
Specification
1. Frequency: 2.4GHz ISM band(2400MHz~2483.5MHz)
8. 10 modes memory storage
10. Control distance: more than 400 meters
11. LCD screen: 128*64 resolution, LCD back light
12. Power supply: 4.8~10.0V DC
13. Channel resolution: 4096
15. Compatible with transmitters: RC6GS, RC4GS, RC4G, RC3S, T8FB
To Previous Page
Loading...
