RADIOLINK ELETRONIC LIMITED
www.radiolink.com
the lower right corner and press “Enter”
4) As the searched CH7_OPT shown in the MP, change the value to 40 (Object Avoidance).It means
switchon/off CH7 enable/disable the avoidance function.
5) Click “Write Params”on the right to save the parameters when the setting is complete.
Transmitter setting steps
1) Choose a 2-position switch(the SWA of AT9S for example) to control CH7
2) Choose INITIAL SETUP on the top of the interface
3) Click “FailSafe”in the pull-down menu of “ Madatory Harware” on the left and the PWM value interface
of CH7 is shown
4) Toggle the switch. If the PWM value of CH7 is more than 1800, it means the avoidance function is enabled
when the switch is at the bottom position. If the PWM value of CH7 is less than 1800, it means the avoidance
function is disabled when the switch is at the top position.
To Next Page
Loading...