Various different receivers and models will have different methods to place the model or receiver in to
bind mode. Please follow the instructions from the model or receiver manufacturers user manual to
initial the bind process.
A Note on input sensitivity:
If your craft feels too sensitive to input you may need to set up EXPO. EXPO is a function to soften the
stick feeling in the center of the stick movements. This can help settle down a drone that is very
sensitive to stick movements. This is handled in the flight-controller firmware and varies depending on
the flight controller you are using and may be called EXPO or RC EXPO. Please refer to the setup guide
of your specific drone or flight controller to set EXPO to your desired setting on the models flight
control system.
Specifications
Size: 160*130*45mm
Weight: 218g
Frequency: 2.400GHZ-2.480GHZ
RF Module: Multi-Protocol Module Compatible Single chip (CC2500)
Protocol Options: D8 / D16 v1 FCC / D16 v1 LBT / D16 v2 FCC / D16 v2 LBT
Transmission power: 20dbm
Antenna gain: 2db
Range: > 1km @ 20dbm (depending on the receiver)
Battery: Built in 3.7v 1000mah Lithium battery
Charging: Built in USB-C charging
Firmware: OpenTX T8 Edition (Special T8 Edition, non-configurable) *
Channels: Up to 8 channels (depending on the model / receiver)
Gimbal: High-precision quad bearing potentiometer sensor gimbal
Voice support: Yes (SD Card required)
Option Accessories: 128*64 LCD and OpenTX operation Clip on module
Requires Upgrading to OpenTX T8 Pro firmware
*Does not support or require OpenTX companion or user programming.
EU Simple Declaration of Conformity
RadioMaster declares the radio equipment T8/T8 Pro is in compliance with EU directives Directive
2014/53/EU. Full text of the declaration of conformity is available at the following website
www.radiomasterrc.com Manufactured by
To Next Page
Loading...
