Long press the MDL button to enter the model settings, select MULTI in the SETUP page, and
select the protocol to be used in the sub- options. The system will automatically turn on the
corresponding RF module according to the RF protocol you selected.
Bind [BND] is used to start the binding process.
Range [RNG] button can reduce the power to 1/30 to facilitate testing of remote-control distance.
Notes
OpenTX software is very powerful, and has a large number of programming and mixing functions.
Please download the comprehensive software installation guide from the link below for more detailed
instructions: https://www.open-tx.org or https://www.radiomasterrc.com
Specifications
Size 170*159*108mm
Weight 363g
Frequency 2.400GHZ-2.480GHZ
RF Chip Single-chip Multi-protocol CC2500
Supported Protocols Corona Hitec Futaba S-FHSS Frsky D16/D8 RadioLink Graupner HoTT*
Transmitting Power 20dbm
Antenna Gain 2db
Working Current 160mA@8.4V
Voltage Range 6.6-8.4v DC
Range > 2km @ 20dbm (depending on receiver)
Radio Firmware OpenTX Transmitter / Multi-Module RF module)
Channels Up to 16 (depending on receiver)
Display 128*64 Monochrome LCD display
Gimbal High precision potentiometer gimbals
External module JR/FrSKY/Crossfire compatible
Upgrade Method USB/SD card & OpenTX Companion PC software
* For the most up to date list on supported protocols please visit https://www.multi-module.org/
Warranty and repair
If there is any problem with your remote control hardware, please keep the proof of purchase and
contact the retailer where you purchased the TX12. You may also visit our warranty support page
https://www.radiomasterrc.com/contact
Firmware update and OpenTX
For the latest information and firmware updates from the OpenTX open source firmware development
team, please visit the OpenTX website at https://www.open-tx.org.
EU Simple Declaration of Conformity
RadioMaster declares the radio equipment TX16s is in compliance with EU directives Directive
2014/53/EU. Full text of the declaration of conformity is available at the following website
www.radiomasterrc.com
Manufacturer by
ShenZhen RadioMaster Co., Ltd
5th Floor, Yutian Building, No. 18 Yangtian Road, Xin’an Street, Baoan District, Shenzhen, Guangdong.
FCC ID: 2AV3G-TX12
FCC Information
This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. This
device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Full text of the declaration of
conformity is available at the following website www.radiomasterrc.com
CAUTION:
To Next Page
Loading...
