mode.
- Then ENTER button to confirm and set the dialling mode.
7. Setting Baby Call ( Emergency call) When baby Call is switched
on, the phone will automatically dial the baby call number when
anybutton is pressed.
- Press and hold the ENTER button for 4 sec.(On or Off hook)
- The LCD will show : OPTIONS MENU
- Using (Up) or (Down) button go to “SET BABY CALL”
- Press ENTER to enter in to the menu
- The LCD will show : BABY CALL OFF,
- Use (Up) or (Down) button to set the emergency call.
- The LCD will show : BABY CALL ON
- Press ENTER to enter in to the menu
- Enter the number
- Then ENTER button to confirm and set the mode.
8. Exit menu
Select the ”EXIT OPTION” then press the ENTER button to exit.
9. Message waiting
There are 2 types of Message waiting used by large PBX phone
systems and there are 2 Message waiting LED’s on your telephone,
one for each type:
Type 1 .High Voltage ( 100v ) . To alert you that a message is waiting
the system applies a high Voltage to your extension, this will light the
LED above the message waiting symbol. This LED is also used to
Flash on incoming calls , this is a useful feature if you need to turn
the ringer Off but still need a visual indication that the phone is
ringing. If your sysytem uses this type of message waiting, slide the
message waiting switch, on the rear of the phone, to the HV position
Type 2 . Line reversal . To alert you that a message is waiting the
system reverses the polarity of your extension connection to the
system and lights the LED under the message waiting symbol. If your
system uses this type of message waiting slide the Message Waiting
switch, located on the rear of the phone, to the LR position.
Check with your supplier to confirm the type of message waiting used by
your PBX
To Next Page
Loading...
Need help?
General