9
4. Gently squeeze and then pat out all excess oil and reinstall.
5. Replace the filter if it is damaged.E
Note
Running the engine without the air filter will quickly degrade the engine
Always inspect air filter before using the pressure washer. Check and
clean the air filter according to the maintenance schedule.
3.2 ADD ENGINE OIL
1. Ensure the pressure washer is on a level surface.
2. Unscrew one oil dipstick and clean the dipstick.
3. Check the oil level by reinserting the oil dipstick without screwing it back
in. Remove the dipstick and examine the oil level. If the level is at or below
the minimum oil level marked on the dipstick, refill to the maximum oil
level mark using a funnel.
4. Reinsert the dipstick and tighten securely.
Note
Max. Oil capacity: Max. 400mL
SAE 10W-30 is recommended for general use.
Do not tilt the pressure washer when adding engine oil. This could
result in overfilling and damage to the engine.
Using non-detergent or 2-stroke oil could shorten the engine’s working
life.
Use high quality engine oil with strong detergents.
Handle and store the engine oil with care, avoid getting dirt or dust into
the engine oil.
Maximum Oil Level
Minimum Oil Level
0°C
10 20 30 40 50-10-20-30
20
32°F
40 60 80 100 120
°C
°F0-20
15W-50
10W-30
Synthetic 5W-30
5W-30
Effective Viscosity Range of Engine Oils
To Next Page
