19
5. PRESSURE WASHER OPERATION
DANGER!
NEVER direct the water flow at people. The high pressure jet
can be dangerous if misused and must not be directed at people,
animals, electrical devices or the unit itself. DO NOT TREAT FLUID
INJECTION AS A SIMPLE CUT! Seek medical help immediately.
WARNING!
Do not run the pump without connecting to the water supply and
turning the water on. Failure to do so could damage the pressure
washer. Failure to follow these instructions will void product
warranty. This unit is not drinking water safe.
5.1. USING THE SPRAY WAND
1. Flip the safety down until it clicks to remove the safety.
2. Pull back on the trigger to begin operating pressure washer.
3. To stop water flow, release the trigger.
Note
DO NOT allow the unit to run for more than 2 minutes without the
gun trigger being pulled. This could cause overheating and damage to
the pump. When the temperature inside the pump gets too high the
thermal relief valve will temporarily open and release a spray of water
from the pump to lower the internal temperature.
To Next Page
