- 8 -
Balance assembly
Upon unpacking the balance remove any
protective elements and assembly the
balance:
Install:
• metal weighing pan (2)
• draft shield (1), for balances with pan Φ
115 mm
• plug a power supplier connector into the
port of interfaces housing
• plug the power supplier into the mains
CAUTION!
While cleaning it is advisable to follow below precautions. Additionally it is a must to disconnect the device from
mains and unplug all the peripherals (printers, computer etc.) remembering at the same time to protect ports by
means of stoppers. Only thus prepared device can be cleaned. Upon completion of the cleaning process the
device may be connected to mains for further operation.
1.5. INTENDED USE
X2 series balances are designed to provide accurate measurement of weighed loads, performed
under laboratory conditions. It is intended for application as a non-automatic weighing instrument
To Next Page
Loading...
Need help?
General