6
Ordering & Tech Support: 877-272-6747 www.RainbowEcoscience.com
Instructions For Use
Shut o ball valve before
proceeding to the next injection
site.
4.
Repeat the injection
steps until you have
completed the treatment.
5.
If you have completed injections for the day, proceed to purging the device (below).
6.
7.
1-4
STEPS
Close the ball valve and insert the tee into
device holsters.
1.
2.
VIII.
Finishing Injection
If you are done and don’t plan
on using the device any longer,
proceed to purging the device
(pg. ).
If you want to continue injecting,
proceed to resetting injection
dose (below).
Power o the device by pressing the
power on/o button for 5 seconds
until device goes into sleep mode.
When you are ready to use the
device again press and hold power
button for 5 seconds to turn back on.
1.
2.
IX.
Resetting Injection Dose
Press the reset button
(also power on/o
button) once to reset
total amount injected
and number of doses
and keep injection
dose consistent.
Press the reset but-
ton twice to reset
the dose back to a
10 ml injection dose
and to reset the total
dose count and total
volume injected at
that dose.
close
press 2x
To Next Page
Loading...