7
1. 2.
X.
Purging Product From Lines (Back Into Reservoir)
Open the ball valve on the tee handle and
ensure that reservoir tank is fully inserted into
device.
Press the arrows left or right until the
mode is switched to ‘purge mode’.
3.
Press start/pause to begin running
pump backwards, purging product
from lines back into the tank .
Instructions For Use
General Care & Storage
1.
2.
Daily Cleaning
Thoroughly clean the device with gentle cleanser to remove any chemical residue.
Rinse out device at the end
of each workday with at
least 200 mls of water.
Note: When treating with
3.
After adding water into the
reservoir, remove the resevoir
and swish the water continously
for 5-10 seconds and reinsert the
reservoir into device.
4.
Start the priming sequence until lines
are completely void of water.
5. 6.
Air dry.
Remove
battery from
the device.
open
200+ mls of water
To Next Page
Loading...