Rainfresh R830 User Manual (English)

Other manuals for Rainfresh R830

Installation & Maintenance Instructions6 pages

Replacement2 pages

Questions and Answers:

E
Elizabeth WongAug 8, 2025
What to do if hot water comes out of Rainfresh Laboratory Equipment?
- J
  Jacob GarnerAug 9, 2025
  If hot water is coming out of your Rainfresh Laboratory Equipment taps/faucets, it could be due to the water inside the UV unit heating up during long periods of non-use, or the unit may be too large for the home. To avoid scalding, flush the water for about 2 minutes before using it after periods of non-use, such as overnight. Alternatively, install a temperature-controlled purge valve on the UV outlet.
E
ediazAug 16, 2025
Why is there condensation on my Rainfresh Laboratory Equipment UV chamber?
- D
  Devin CoxAug 16, 2025
  Condensation on the outside of your Rainfresh Laboratory Equipment UV chamber is normal if the humidity in the environment is high. Consider installing a dehumidifier to protect the ballast and protect the flooring below the UV unit.
I
iroblesAug 25, 2025
How to fix a leak at the gland nut of Rainfresh Laboratory Equipment?
- W
  William PierceAug 25, 2025
  If you notice a leak at the gland nut of your Rainfresh Laboratory Equipment, hand-tighten the gland nut and replace the O-ring(s), as the gland nut may be loose or the O-ring defective.
D
davenportandrewAug 31, 2025
What to do if UV lamp ends seem burnt on Rainfresh Laboratory Equipment?
- N
  newtonbethanySep 1, 2025
  The UV lamp ends of your Rainfresh Laboratory Equipment may appear burnt after some time, but this is normal. As long as the UV lamp lights, a little burn mark at the ends is normal, and there is no need to replace the UV lamp.

Rainfresh R830 Specifications

General

Type	Reverse Osmosis System
Storage Tank Capacity	3.2 gallons
Installation	Under Sink
Filter Life	6-12 months (pre-filters), 2-3 years (membrane)
Operating Pressure	40-80 psi