RAK WisBlock Kit 3 - User Manual

Documentation Center
Installation Guide
Assembly List
Figure 1: Assembly list
Assembly
Step 1: Fix the WisIO module with three M1.2*3 screws. For assembly method and precautions, refer to
RAK5005-O Baseboard Installation Guide.
Figure 2: Attaching WisIO Module
Step 2: Fix the WisBlock module on the plate with M2.5*4 screws.
📝 NOTE
The number of screws is related to the specific module, confirm according to the actual module.
Figure 3: Attaching WisBlock Module to the Enclosure

Summary

Assembly List Overview

Assembly Procedures

Fix WisIO Module

Fix the WisIO module with three M1.2*3 screws. Refer to RAK5005-O Baseboard Installation Guide.

Fix WisBlock Module

Fix the WisBlock module on the plate with M2.5*4 screws. Confirm screw count with the actual module.

Attaching Antenna

Connect N-type antenna, fix it, and plug the other end to the WisBlock IPEX connector.

Attaching Built-In Antenna

Stick the built-in antenna on the inner wall of the enclosure as shown in the figure.

Battery Installation

Fix the battery with cable tie or sticker, and insert the battery plug into the PCB socket.

Cover Installation

Fix the cover with screws and fasten decorative covers to complete the installation.

Installation Methods

Wall Mounting Steps

Drill 4 holes according to dimensions and plug screw anchors. Then attach the device using tapping screws.

Pole Mounting Steps

Fix the installation kit to the enclosure with screws, then use steel band clamps to secure it to a pole.

Protection Treatment

Seal N-type Antenna

Connect and tighten the N-type antenna, then wrap with PVC and waterproof tape for protection.

RAK WisBlock Kit 3 Specifications

General

Sensitivity Acquisition	-148 dBm
Accuracy	2.5 m CEP
Time-To-First-Fix (Cold Start)	29s
Operating Voltage	3.3V
Operating Temperature	-40°C to +85°C
GNSS	GPS, GLONASS, BeiDou, Galileo, QZSS
Frequency	L1 (1575.42 MHz)
Update Rate	1 Hz
Time-To-First-Fix (Warm/Hot Start)	1s
Interface	UART, I2C
Antenna	External