RAM Promaster 2014 - Tuner Mode (AM;FM Radio)

Volume
Turn the ROTARY knob clockwise to increase the vol-
ume. Turning it counterclockwise will lower the volume.
The volume can be set between 0 and 30.
Tuner Mode (AM/FM Radio)
When you enter TUNER mode, the radio tunes to the
most recently selected station and will remain on the
most recently selected frequency band.
In this mode of operation the display will show one of the
following 5 codes:
CH (Channel)
When this is on, it indicates that the current radio station
is stored in memory. The code is only shown when the
tuned frequency is showing on the display.
ST (Stereo)
When this is on, it indicates that the radio station is
transmitting a 19 kHz signal (pilot).
Searching for Stations In Automatic Mode
When you press or for less than two seconds, the
radio will search for the next valid station. While the
radio is searching for the new station, the display will
show ⬙SEEKING⬙. When the search is complete, the
display will show the tuned frequency band and station
in the format ⬙F1 106.9⬙ or, if the station was previously
stored in memory, the display will show the channel
where it is stored and the tuned station.
Searching for Stations In Manual Mode
Pressing
or for more than two seconds displays the
selected radio station frequency. Each time a button is
pressed, the radio station frequency is increased or
decreased according to the default search pattern for the
150 UNDERSTANDING YOUR INSTRUMENT PANEL