What to do if my RAMSET RAM 30 Gate Opener doesn't open?
If the Radio L.E.D. is 'On', refer to the solutions for that specific symptom. Otherwise, check or replace the 10 amp fuse and inspect or replace the opening accessory.
What to do if my RAMSET RAM 30 Gate Opener doesn't close?
If no lights are 'On' or if the Exit, Rev Loop, or Radio L.E.D. is 'On', refer to the solutions for those specific symptoms. Additionally, check or replace the 10 amp fuse. Also, verify if the thermal/overload button has popped on the motor; if so, reset it on the back of the motor.
Why does my RAMSET RAM 30 Gate Opener radio/receiver have no range?
The signal might be blocked. Ensure the antenna is in the proper position and not shorted to the chassis. Alternatively, the area may not be suitable for the current type of receiver, and you might need to change to a long-range receiver.
How to fix a RAMSET Gate Opener that doesn't close automatically?
If dip switches "A" 1-3 are all 'Off', set them for auto close. If a dip switch is not fully on, turn off dip switches "A" 1-3, then turn the appropriate switches back 'On'.
Why no lights are on my RAMSET RAM 30 Gate Opener?
Try the following solutions: reset the circuit breaker, replace the 1/2 amp fuse, or return the Control Board for repair.
What to do if RAMSET RAM 30 moves a couple of feet and then reverses?
The E.R.D. might be too sensitive. For 1/2 hp motors, turn dip switch "A" 4 'On'. For 3/4 hp motors, turn dip switch "B" 8 'On'.
Why is the 'RADIO' L.E.D. always on in my RAMSET RAM 30 Gate Opener?
A possible cause is a stuck button on the transmitter, so check all transmitters. Another cause may be a faulty receiver; remove the receiver and if the problem persists, contact Ramset.
What to do if my RAMSET RAM 30 automatically opens, but doesn't automatically close?
The motor direction might be wrong. Turn on dip switch "C" 7 (left/right).
What to do if 'EXIT' L.E.D. is always on on RAMSET RAM 30 Gate Opener?
A faulty accessory connected to the "Exit" may be the cause. Disconnect all accessories, including plug-ins, using the "Exit" input. If the problem persists, contact Ramset.
What to do if 'REV LOOP' L.E.D. is always on on RAMSET RAM 30?
A faulty accessory connected to the "Rev Loop" might be the problem. Disconnect all accessories, including plug-ins, using the "Rev Loop" input. If problem persist, contact Ramset.
Step-by-step instructions on how to manually release the gate during a power failure.
Detailed instructions and dimensions for constructing the concrete pad for the gate operator.
Details on required safety sensors like loops and photo eyes, and their proper installation.
Overview of the Intelligate Control Board, its functions, and key components like power, dipswitches, and connections.
General| Brand | RAMSET |
|---|---|
| Model | RAM 30 |
| Category | Gate Opener |
| Language | English |
To Next Page
