14
3
UNIT SOUNDS
Sound Issue: Call Point unit periodically beeping after an alarm has been reset
The Call Point is latched and needs to be manually reset using the key provided.
Sound Issue: WES3 CONNECT beeps frequently
System warning. If alarm has been raised, LCD screen will display ‘ALARM ALARM
ALARM’ together with details of which unit has raised the alarm.
If another warning is given, check the warning code against the warning code
table on page 13.
4
SILENCING THE ALARM
The alarm must be silenced either by using the reset key or on the WES3
CONNECT unit.
The alarm will automatically silence 30 minutes after activation. The evacuation
alarm can be manually cancelled from a Call Point that has been pressed using
the reset key provided. If necessary, a Call Point on a nearby Call Point can be
pressed and then reset to cancel the alarm.
Please wait for 5 seconds between pressing and resetting a Call Point. After the
alarm has cleared the system has a short (2 minute) re-arm period during which
the sirens will sound intermittently, and the amber warning LEDs flash in groups
of 5, following which the system is re-armed and ready for use.
During the re-arm period, the alarm cannot be reactivated. It is therefore vital to
confirm that there is no hazard before silencing the alarm.
RAMTECHGLOBAL.COM/WES/
Note: It is vital to confirm that there is no hazard before silencing the alarm. Do not
attempt to open the unit or deactivate by removing the battery.
To Next Page
Loading...
