4
SETTING UP WES3
Installing WES3 on your site is easy. You will need to start by activating /
powering on each unit and add the units to the group so that they can
communicate with each other.
1
INITIAL SETUP
STEP 1 Activate and power on
To activate/power on the WES3 CONNECT control unit, hold down ‘A’ and
press ‘B’ three times in quick succession. All three LEDs will illuminate and then
the amber LED will flash.
Initial setup of the WES3 CONNECT is through a series of on-screen options.
Language, Inspection Delay and Pre-Alarm mode options can be configured.
STEP 2 Language selection
Select language - the available options are English, German, French, Spanish,
Italian, Swedish or Polish. Language settings can be changed at any time.
STEP 3 Set inspection delay
The Inspection Delay setting allows an optional delay period between
triggering a Call Point and the site wide alarm being raised.
The default setting is 00 minutes (i.e. no delay), but can be set in 1 minute
increments up to a maximum 10 minutes.
A confirmation screen will be displayed to validate the settings. The Inspection
Delay can only be set during the initial activation process.
WES3 CONNECT | RAMTECHGLOBAL.COM/WES/
To Next Page
Loading...
